Mũi khoan, HSS-G, 9,0

• Produce holes for fasteners, pins, and general fabrication work in workshop and site service.
• Process: manual driving or assisted driving depending on your holder and machine setup
• Use: cắt ren, taro lại ren, and làm sạch ren depending on condition
• Clean chips from the tool and hole regularly to reduce torque peaks and edge chipping.

Lưu ý Use a stable setup and correct lubrication for the alloy to avoid heat driven wear.

• General purpose hole making for workshop tasks
• Stable cutting edges when your setup is consistent
• Suitable for preparation steps before threading and assembly
• Simple tool selection when diameter is defined in the product name

• Sensitive to misalignment, especially during the first turns
• Not intended for high performance production cycles without validated process parameters

1. Mark the drilling point and secure the workpiece with stable clamping.
2. Center the tool and start with straight alignment to the surface.
3. Apply suitable lubrication for the work material if your process requires it.
4. Drill with consistent feed while allowing chips to evacuate freely.
5. Retract to clear chips when needed and avoid rubbing at low feed.
6. Deburr the hole edge and clean the bore before the next process step.

• 1 chiếc Mũi khoan, HSS-G, 9,0

• Product type: Mũi khoan
• Tool material: HSS-G