Mũi khoan, HSS-G, 8,5 (M10)

• Drill holes for assembly and machining tasks, including preparation for subsequent threading when required.
• Process: manual driving or assisted driving depending on your holder and machine setup
• Use: cắt ren, taro lại ren, and làm sạch ren depending on condition
• Use a suitable Chất bôi trơn cắt gọt ren for the work material and keep the tool aligned to the axis.

Lưu ý Clear chips frequently to reduce friction and to keep the cutting edges protected.

• General purpose hole making for workshop tasks
• Stable cutting edges when your setup is consistent
• Suitable for preparation steps before threading and assembly
• Simple tool selection when diameter is defined in the product name

• Not suitable for every work material without correct cutting fluid and stable alignment
• Not intended for high performance production cycles without validated process parameters

1. Mark the drilling point and secure the workpiece with stable clamping.
2. Center the tool and start with straight alignment to the surface.
3. Apply suitable lubrication for the work material if your process requires it.
4. Drill with consistent feed while allowing chips to evacuate freely.
5. Retract to clear chips when needed and avoid rubbing at low feed.
6. Deburr the hole edge and clean the bore before the next process step.

• 1 chiếc Mũi khoan, HSS-G, 8,5 (M10)

• Product type: Mũi khoan
• Thread designation: M
• Tool material: HSS-G