Hand Tap Rougher DIN 2181 HSS-G - M 70 x 4.0

• Process: manual driving or assisted driving depending on your holder and machine setup.
• Use: thread cutting, re tapping, and thread cleaning depending on condition.
• Use it when you need to match the metric designation and pitch stated in the title.
• Use it for maintenance jobs where controlled tool guidance is important in the first pass.
• Use it as the first stage in a staged hand tap sequence when you want a guided thread start.

Note Align the tool carefully and use lubrication suitable for your workpiece material to support surface quality and tool life.

• DIN 2181 reference supports standardised selection and documentation in production planning
• Useful when you want to reduce corrective rework by creating a clean initial thread path
• Suitable for routine threading tasks in maintenance and fabrication environments
• Supports a staged tapping sequence where the first pass establishes guidance for later tools

• May be limited in hard or scale covered surfaces where edge load becomes high at the start of the cut
• Less efficient for large series work where process time and consistent feed control are critical

1. Verify the required internal thread on the drawing and match it to the product title.
2. Prepare the bore entry by removing sharp edges and ensuring the tap can start square.
3. Select cutting lubricant appropriate for the workpiece and apply it before engaging the tool.
4. Secure the tap in a suitable holder and check that the tool runs true by hand.
5. Drive the tap with controlled torque while maintaining straight guidance along the bore axis.
6. Maintain chip evacuation by periodic cleaning and continued lubrication as required. Technical information hand taps as PDF
7. Withdraw the tap, clean the thread form, and store the tool in a protected environment.

• 1 piece: Hand Tap Rougher DIN 2181 HSS-G - M 70 x 4.0

• Standard: DIN 2181
• Material: HSS-G
• Tool type: Hand tap rougher
• Thread designation: M 70 x 4.0
• Thread system: Metric internal thread, as designated in the title
• Execution: Ground, depending on variant

Use a tap wrench or suitable holder that clamps the square reliably and keeps the tool aligned. Select the interface based on your tap size and your available guidance method.

Yes. The thread designation in the title includes both diameter and pitch, which helps you distinguish fine pitch variants from other executions of the same nominal diameter.

DIN 2181 supports standardised identification for hand taps. It helps you align purchasing, documentation, and workshop instructions with a recognised designation.

Match the metric thread designation in your drawing to the product title, including the pitch value, because the pitch differentiates otherwise similar diameters.

Rougher refers to the first tap stage in a staged hand tapping sequence. You use it to establish the initial thread form and guidance before you use subsequent taps, depending on your set and process.

You can use it for controlled re tapping and for cleaning of existing threads when the thread form is intact, but the result depends on thread condition and how much material must be removed.

For additional information and the full range overview, use the catalog link. VD 23 catalog as PDF