Die Stock steel 150 x 25 mm

• Hold round dies so you can cut external threads with controlled alignment and stable guidance.
• Process: manual driving or assisted driving depending on your holder and machine setup
• Use: thread cutting, re tapping, and thread cleaning depending on condition
• Clamp the die evenly and keep the tool axis aligned to the workpiece to reduce flank damage.
• Use lubrication and clear chips regularly to limit torque and prevent galling.

Note Keep the setup clean and check the thread with a gauge or mating part after cutting.

• Controlled holding of round dies for external thread cutting
• Even clamping to keep the die aligned
• Practical handling for workshop use and repair work

• High torque applications can require stronger tooling and rigid fixturing
• Manual operation is slower than automated production methods

1. Select a round die that matches the die seat of the stock.
2. Open the clamping screws and place the die into the seat with correct orientation.
3. Tighten the screws evenly to clamp the die without distortion.
4. Align the die to the workpiece axis and apply suitable cutting fluid.
5. Start the cut with steady torque while keeping the die square to the workpiece.
6. Reverse slightly at intervals to clear chips from the die.
7. Back off fully after the required thread length and clean the tool.
8. Inspect the external thread with a mating part or gauge.

• 1 piece Die Stock steel 150 x 25 mm

• Product type: Die Stock
• Body material: Steel

How do you select the correct thread designation for this tool
Match the designation in the product name to the drawing, the mating part, and the required thread series, then align the tool choice with the hole type and manufacturing route.

Which holder is typically used for machine tapping
A tapping chuck or rigid holder is commonly used, and alignment to the hole axis is critical to prevent side load on the tap.

How do you reduce the risk of tap breakage
Keep alignment, use suitable lubrication, avoid side loading, and clear chips from the flutes so torque does not rise suddenly.

Which workpiece materials are typical for this threading tool
Thread cutting tools are commonly used in steels, cast iron, and many non ferrous alloys, but you should adapt lubricant choice and process control for hard, sticky, or abrasive materials.

How do you check thread quality after tapping
Use a suitable gauge or the intended mating part to confirm functional fit, and inspect the first threads for damage or misalignment.

Do you need lubrication and how do you manage chips
Use a cutting fluid suitable for the material to reduce friction, and clear chips from the flutes during the process to keep torque stable.

Where can you find additional technical information for selection and standards
For an overview of threading tools and related standards, refer to the VD 23 catalog as PDF.