V-COIL Dụng cụ lắp ren cấy (Drive connector 1/4") M 14 x 1,25

• Installation of Ren cấy V-COIL in size M 14 x 1,25
• Suitable for repair, maintenance and serial production
• Usable in aluminium, thép and many other materials
• Compatible with V-COIL systems and many equivalent inserts

Follow these steps for a clean and precise installation:

• Prepare and clean the pilot hole according to specifications.
• Screw the Ren cấy V-COIL all the way onto the Dụng cụ lắp ren cấy.
• Align the tool with the thread entry and install using your 1/4" drive.
• Remove the tool once the insert is fully seated.

1. Preparation: Drill the pilot hole, use the correct tap and remove chips and oil.
2. Mounting: Screw the insert onto the Dụng cụ lắp ren cấy.
3. Alignment: Position the tool straight at the hole entrance.
4. Installation: Apply steady torque until the insert is fully in place.
5. Finish: Remove the tool and check the insert alignment.

• Thread size: M 14 x 1,25
• Drive Connector: 1/4" square
• Compatibility: V-COIL and compatible Ren cấy V-COIL
• Material: Precision thép
• Article Number: 08193
• EAN: 4022835081937

1. Which inserts is this tool compatible with?

This tool is designed for Ren cấy V-COIL in size M 14 x 1,25 and fits V-COIL and many equivalent systems.

2. Can I use the tool manually?

Yes — you can use it manually, but a 1/4" drive ratchet or torque wrench ensures more consistent results.

3. Does this tool remove old inserts?

số This tool is only for installation. Removing inserts requires a dedicated extraction tool.

4. Do I need to break off the tang?

For inserts with a tang, you must break it off after installation using the appropriate tang-break tool.

5. What if the insert is not aligned properly?

Check the hole and thread for damage or debris. If everything is fine, remove the insert and install a new one.

6. Can I use this tool in tight spaces?

Yes — its compact design allows access to difficult or confined areas.

7. How should I clean the thread before installation?

Use compressed air, a thread brush and a lint-free cloth to remove oil and debris.

8. How do I know the insert is positioned correctly?

The insert should sit flush or slightly below the surface. Check visually and dimensionally.

• 1× V-COIL Dụng cụ lắp ren cấy, 1/4", M 14 x 1,25 (Art. số 08193)