Dụng cụ bẻ chân ren cấy số 2

Application:

• For removing the driving tang of V-COIL thread inserts after their installation.
• Suitable for thread inserts up to and including M12. For thread inserts from M13 onwards, we recommend removing the driving tang with needle-nose pliers.

Advantages:

• Easy Handling: The Dụng cụ bẻ chân ren cấy allows for quick and effortless removal of the tang.
• Clean Result: Breaks the tang precisely at its pre-determined breaking point, without damaging the freshly cut thread or the insert.
• Efficiency: Speeds up the work process for sửa ren and reinforcement.
• Specific size: số 2 is suitable for a variety of common thread inserts.

Using the V-COIL Dụng cụ bẻ chân ren cấy is incredibly simple:

1. Install Insert: Ensure that the V-COIL thread insert is fully and correctly screwed into the prepared thread.
2. Position Dụng cụ bẻ chân ren cấy: Carefully insert the V-COIL Dụng cụ bẻ chân ren cấy through the newly installed thread insert until it rests on the driving tang.
3. Break Tang: Apply a short, firm pressure to the Dụng cụ bẻ chân ren cấy. The driving tang will cleanly break off at its pre-defined breaking point.
4. Remove Residue (if necessary): Should small remnants of the tang remain in the thread, they can be easily removed to ensure the thread's clear passage.

After this step, the thread is fully prepared and ready for use.

• Standard: Factory Standard
• Nominal size: số 2 (suitable for thread inserts M 2 x 0.4, M 2.2 x 0.45, UNC số 2)
• EAN: 4022835070023
• Item Number: 07002

1. Which thread inserts is the Dụng cụ bẻ chân ren cấy số 2 suitable for?
The Dụng cụ bẻ chân ren cấy số 2 is suitable for V-COIL thread inserts of sizes M 2 x 0.4, M 2.2 x 0.45, and UNC số 2.

2. Why must the driving tang be removed?
The driving tang is used to screw the thread insert into the receiving thread during installation. After installation, it serves no further purpose and would block the thread's passage, which is why it must be removed.

3. Can I remove the tang with pliers?
For thread inserts up to M12, using the Dụng cụ bẻ chân ren cấy is the cleanest and safest method, as it separates the tang at the intended breaking point. From M13 onwards, the tangs are more robust and can generally be removed with needle-nose pliers.

4. What if the tang doesn't break cleanly?
Typically, the tang breaks cleanly at its pre-determined breaking point. If this doesn't happen, check if the thread insert is fully screwed in and if the Dụng cụ bẻ chân ren cấy is correctly positioned. A light but firm pressure is usually sufficient.

5. Are there different sizes of tang break tools?
Yes, V-COIL offers tang break tools in various sizes, matched to the respective thread insert sizes, to ensure optimal fit and breaking performance. Make sure to choose the correct size for your thread insert.