Tay quay bàn ren Holder Zinc Die-Cast 20 x 5 mm (5 chiếc)

• Clamp a Bàn ren ngoài (tạo ren ngoài) securely so you can guide an ren ngoài operation with controlled manual feed.
• Support alignment at the thread start when you are cutting a new ren ngoài or reworking an existing one.
• Use in workshop repair, maintenance, and fabrication where manual die handling must remain stable.
• Keep the die secured by the clamp screws so the holder and die act as one assembly during use.

Lưu ý Confirm that the die outside diameter and thickness match the holder size before you clamp the die.

• Clamps the Bàn ren ngoài (tạo ren ngoài) securely for more controlled manual handling.
• Supports a square thread start when you align the holder correctly.
• Simple construction is easy to clean and keep ready for workshop use.
• Suitable for ren ngoài cutting and thread chasing with matching Bàn ren ngoài (tạo ren ngoài).

• The holder only fits Bàn ren ngoài (tạo ren ngoài) that match the stated holder size.
• It is intended for manual handling, not for improvised high speed powered use.

1. Clean the holder and the Bàn ren ngoài (tạo ren ngoài) seating area before assembly.
2. Insert the Bàn ren ngoài (tạo ren ngoài) into the holder with the lead side oriented for the intended cut direction.
3. Tighten the clamp screws evenly so the die sits securely in the central body.
4. Place the holder square to the workpiece and start the die carefully on the prepared rod or thread end.
5. Guide the holder with steady torque so the die advances without tilting.
6. Remove the die after the pass, clean the holder, and protect the clamping surfaces for the next job.

• 1 chiếc Tay quay bàn ren Zinc die cast 20 x 5 mm

• Product type: Tay quay bàn ren
• Holder size: 20 x 5 mm
• Construction: Zinc die cast
• Intended tool: Bàn ren ngoài (tạo ren ngoài)

How do you choose the correct Tay quay bàn ren?

Match the holder size stated in the product name to the outside diameter and thickness of the Bàn ren ngoài (tạo ren ngoài) you plan to clamp.

Can you use this holder for new threads and for sửa ren?

Yes. A Tay quay bàn ren is used both for cutting new ren ngoài and for chasing or restoring existing ones when a matching Bàn ren ngoài (tạo ren ngoài) is installed.

Why does square alignment matter so much?

If the die starts tilted, the ren ngoài can cut unevenly and the holder will be harder to control throughout the pass.

Where can you read more about Bàn ren ngoài (tạo ren ngoài) and ren ngoài cutting?

Technical information Bàn ren ngoài (tạo ren ngoài) as PDF

What should you check after clamping the die?

Check that the die sits flat, the lead side faces the intended start direction, and the clamp screws hold it securely without movement.

Where can you find the full threading tools catalog?

VD 23 catalog as PDF

Is this a powered production holder?

số This style is intended for controlled manual handling rather than improvised high speed power use.