Mũi khoan gỗ 5mm chuôi lục giác 6.3mm, Voelkel 67650

• Produce holes for fasteners, pins, and general fabrication work in workshop and site service.
• Process: manual driving or assisted driving depending on your holder and machine setup
• Use: cắt ren, taro lại ren, and làm sạch ren depending on condition
• Clean chips from the tool and hole regularly to reduce torque peaks and edge chipping.

Lưu ý Use a stable setup and correct lubrication for the alloy to avoid heat driven wear.

• General purpose hole making for workshop tasks
• Stable cutting edges when your setup is consistent
• Suitable for preparation steps before threading and assembly
• Simple tool selection when diameter is defined in the product name
• Suitable for routine use in metal fabrication and plant engineering service

• Limited by work material hardness and by the stability of your clamping setup
• Practical speed is limited by manual handling and by access conditions at the workpiece

1. Mark the drilling point and secure the workpiece with stable clamping.
2. Center the tool and start with straight alignment to the surface.
3. Apply suitable lubrication for the work material if your process requires it.
4. Drill with consistent feed while allowing chips to evacuate freely.
5. Retract to clear chips when needed and avoid rubbing at low feed.
6. Deburr the hole edge and clean the bore before the next process step.

• 1 chiếc Wood Mũi khoan, HSS-G, 5,0

• Product type: Wood Mũi khoan
• Tool material: HSS-G