Hand Tap Second ISO 529 Form D HSS-G - M 9 x 1.0

• Support maintenance in mechanical engineering, plant engineering, and metal fabrication when replacement parts must match existing fasteners.
• Cut internal threads in drilled holes for new production and repair work.
• Select the tool by matching the thread system and series from the designation to the mating screw or drawing requirement.
• Use a suitable tap holder or tap wrench to keep the tool aligned and to avoid side load.
• Process: manual driving or assisted driving depending on your holder and machine setup.
• Use: thread cutting, re tapping, and thread cleaning depending on condition.

Note Use cutting fluid suitable for the work material and keep the tool square to the hole axis.

• Clear thread designation supports correct selection and documentation.
• Tool geometry terms in the name support consistent process planning.
• Suitable for workshop use when hole preparation and alignment are controlled.
• Material abbreviation in the name supports expectations for heat resistance tendency and wear behavior.
• Standard references help you align shop language with drawings and work instructions.

• Not intended for brittle materials without an adapted tapping strategy and adequate lubrication.
• Not suitable for high performance production without rigid alignment and controlled coolant supply.

1. Confirm that the designation matches the required thread system and the intended hand or machine use.
2. Prepare the hole with the correct core hole drill and a clean chamfer.
3. Mount the tool in a suitable holder and align it to the hole axis.
4. Apply cutting fluid that matches the work material and process.
5. Start the cut with steady feed and keep alignment constant.
6. Periodically reverse slightly to clear chips and reduce torque.
7. Continue to the required thread depth, then back the tool out fully.
8. Clean the thread and check it with a suitable gauge or mating part.

• 1 piece Hand Tap Second ISO 529 Form D HSS-G - M 9 x 1.0

• Product type: Hand tap
• Standard: ISO 529
• Chamfer form: Form D
• Thread system: M
• Material marking: HSS-G

How do you confirm that the tool matches the required thread

Match the complete designation to the drawing or the mating screw, including thread system, series, and direction. Avoid mixing similar looking inch and metric systems during preparation.

When do you use a hand tap instead of a machine tap

Use a hand tap when you need controlled manual guidance, for example in maintenance or on large workpieces where machine access is limited. Use a machine tap when the feed is guided and the setup can keep the tool aligned.

How do form letters and flute terms affect your selection

Form D describes the chamfer style and influences how the tool starts and how deep you can thread before full profile is reached.

How do you prepare the hole before tapping

Drill the correct core hole, remove burrs, and add a small chamfer to support clean thread entry. Clean the hole and apply cutting fluid suitable for the work material before you start.

Where can you find detailed technical notes for this tool type

Technical information hand taps as PDF

How do you reduce the risk of tool breakage

Keep the tool aligned, use adequate lubrication, and avoid side load during entry. Clear chips regularly and stop if torque rises unexpectedly.

Where can you find catalog information for this threading tool

VD 23 catalog as PDF

What do material abbreviations such as HSS or HSSE indicate

HSS-G indicates a ground high speed steel execution where grinding can support edge definition and consistency.