Combined Mũi taro máy with round shank and square drive 30° Spiral Flute HSSE - M 3 x 0.5

• Create ren trong in pre-drilled holes for fasteners and fittings in mechanical engineering and maintenance.
• Use with a suitable tap holder or a Tay quay taro, depending on whether you work on a machine or by hand.
• Use in general workshop work and small series production where thread quality and alignment matter.
• Process: manual driving or assisted driving depending on your holder and machine setup
• Use: cắt ren, taro lại ren, and làm sạch ren depending on condition

Lưu ý Confirm the thread standard on the drawing before machining and keep the tool aligned during the first turns.

• Supports repeatable thread quality when the correct execution is selected for the hole type.
• Suitable for workshop and production use across common engineering materials.
• Allows a standardized tapping process with predictable tool handling.
• Tool geometry supports chip evacuation when used with suitable lubrication.

• Incorrect alignment can quickly cause thread damage or tool failure.
• Not intended for extreme high speed tapping without process validation.

1. Confirm the thread standard and choose the correct tool execution for the hole type.
2. Prepare the pre-drilled hole according to your process plan and clean the entry.
3. Clamp the tool in a suitable holder or Tay quay taro so that it runs true.
4. Align the tool square to the surface and apply a suitable cutting fluid.
5. Start tapping with steady feed and keep alignment constant through the first turns.
6. Advance with controlled rotation while allowing chips to evacuate.
7. Reverse the tool as needed to clear chips without applying excessive load.
8. Stop at the required engagement and withdraw the tool.
9. Clean the thread and verify fit with the mating fastener or a gauge.

No bill of materials is available in the provided file for Combined Mũi taro máy with round shank and square drive 30° Spiral Flute HSSE - M 3 x 0.5. Check your order confirmation for the exact included items and quantities.

• Product type: Combined tap
• Thread system: Metric
• size: M 3 x 0.5
• Material: HSSE cobalt alloyed high speed thép
• Geometry: spiral flute
• Tolerance class: ISO2 6H

How do you choose the correct tap or die for your thread standard?
You identify the thread system and pitch from the drawing and match it to the tool designation. You also select the correct chamfer form for lỗ thông or lỗ bít.

Where can you find additional technical information relevant to this product type?
For background and selection guidance you can use the following document. Technical information machine taps as PDF

What holder type should you use for reliable alignment?
For machine use you clamp the tool in a suitable tap holder or collet, and for manual work you use a Tay quay taro or a die holder. You avoid freehand starting where alignment cannot be controlled.

What lubrication should you use during threading?
You use a cutting fluid suitable for the workpiece material and your process. Lubrication reduces friction and supports cleaner chip evacuation.

How do you reduce the risk of a broken tap?
You keep the tool aligned, avoid overloading, and ensure the pre-hole is prepared correctly. If resistance increases you stop and remove chips before continuing.

Where can you find additional technical information in the catalog?
You can use the catalog for product families, standards references, and selection guidance. VD 23 catalog as PDF

Can you rework an existing thread with the same tool?
Depending on thread condition you can refresh a thread, but you avoid forcing the tool into damaged profiles. You clean the thread and confirm that the tool enters smoothly.