Mũi taro ren tay (tạo ren trong) Intermediate DIN 352 HSS-G - M 100 x 6.0

• Create metric ISO ren trong by hand in thép and comparable alloys, depending on workpiece condition and cutting fluid.
• Use when you want controlled thread geometry for assembly without additional forming steps.
• Suitable for staged hand tapping sequences where an intermediate tap is required.
• Applied in maintenance and repair environments where you need repeatable thread quality for assembly.
• Process: manual driving or assisted driving depending on your holder and machine setup
• Use: cắt ren, taro lại ren, and làm sạch ren depending on condition

Lưu ý Start the tool square to the hole axis, use suitable cutting fluid, and keep the Tay quay taro stable to protect the cutting edges.

• Ground HSS G execution supports a clean cutting edge
• DIN 352 reference supports consistent tool selection
• Intermediate lead geometry supports staged hand tapping sequences
• Suitable for manual internal threading in workshop maintenance
• ren hệ mét ISO focus supports common fastener systems

• Not suitable for very hard or highly abrasive materials, depending on execution
• Not intended for high performance tapping without rigid guidance and controlled coolant

1. Confirm thread specification and tolerance before you start.
2. Prepare the pilot hole, deburr the entry, and clean the bore.
3. Secure the workpiece so the hole axis stays stable.
4. If you use a staged tap sequence, run the first stage tap before this intermediate tap.
5. Use suitable lubrication and start the tool square to the hole.
6. Turn with steady hand pressure and keep alignment consistent.
7. Stop if torque rises sharply and clear chips before you continue.
8. Remove the tool and check thread function.

• 1 chiếc intermediate Mũi taro ren tay (tạo ren trong) in the selected size

• Tool type: Intermediate Mũi taro ren tay (tạo ren trong)
• Standard: DIN 352
• Material: HSS-G
• Nominal size: M 100 x 6.0
• Thread type: ren hệ mét ISO, depending on execution
• Tolerance class: Depending on execution
• Coating: Depending on execution

Intermediate describes the second stage tool in a common hand tapping sequence. It is typically used after a lead tap to deepen and refine the thread profile, depending on your process.

Not always, but many manual processes use multiple stages to control cutting forces and alignment. Check your shop standard and the required thread depth before you decide.

Yes, depending on your holder and setup you can drive the tool by hand or with a machine. Focus on alignment, lubrication, and controlled torque to protect the cutting edges.

Typical signs are rising torque, rough thread flanks, and inconsistent fit with the mating part. Replace the tap if the cutting edges look rounded or chipped.

Use a drill size recommendation that matches the thread and tolerance requirement. Use a chart from your process documentation or the manufacturer, and avoid guesswork.

Use this document for selection guidance and general process parameters: Technical information Mũi taro ren tay (tạo ren trong) as PDF.

Yes, depending on your holder and setup you can drive the tool by hand or with a machine. Focus on alignment, lubrication, and controlled torque to protect the cutting edges.

For the full overview use: VD 23 catalog as PDF.