Mũi taro ren tay (tạo ren trong) Intermediate DIN 352 HSS-G - M 96 x 6.0

• Create metric ISO ren trong by hand in thép and comparable alloys, depending on workpiece condition and cutting fluid.
• Use when you want controlled thread geometry for assembly without additional forming steps.
• Suitable for staged hand tapping sequences where an intermediate tap is required.
• Applied in maintenance and repair environments where you need repeatable thread quality for assembly.
• Process: manual driving or assisted driving depending on your holder and machine setup
• Use: cắt ren, taro lại ren, and làm sạch ren depending on condition

Lưu ý Start the tool square to the hole axis, use suitable cutting fluid, and keep the Tay quay taro stable to protect the cutting edges.

• Intermediate Mũi taro ren tay (tạo ren trong) supports controlled progression in a tap set
• HSS G ground execution supports consistent edge geometry
• DIN 352 proportions support predictable handling
• Suitable for manual threading with standard tap wrenches
• Supports repeatable assembly fit when preparation is correct

• Not suitable for very hard or highly abrasive materials, depending on execution
• Not intended for high performance tapping without rigid guidance and controlled coolant

1. Verify the required thread specification.
2. Create the pilot hole and remove burrs at the entry.
3. Hold the Tay quay taro square to the hole axis.
4. If your process uses multiple stages, use this intermediate tap after the lead tap.
5. Apply cutting fluid suitable for the material.
6. Cut the thread with steady rotation and controlled torque.
7. Clear chips as needed and avoid forcing the tool.
8. Clean the thread and verify fit.

• 1 chiếc intermediate Mũi taro ren tay (tạo ren trong) in the selected size

• Tool type: Intermediate Mũi taro ren tay (tạo ren trong)
• Standard: DIN 352
• Material: HSS-G
• Nominal size: M 96 x 6.0
• Thread type: ren hệ mét ISO, depending on execution
• Tolerance class: Depending on execution
• Coating: Depending on execution

Intermediate describes the second stage tool in a common hand tapping sequence. It is typically used after a lead tap to deepen and refine the thread profile, depending on your process.

Not always, but many manual processes use multiple stages to control cutting forces and alignment. Check your shop standard and the required thread depth before you decide.

Yes, depending on your holder and setup you can drive the tool by hand or with a machine. Focus on alignment, lubrication, and controlled torque to protect the cutting edges.

Yes, depending on your holder and setup you can drive the tool by hand or with a machine. Focus on alignment, lubrication, and controlled torque to protect the cutting edges.

Use a drill size recommendation that matches the thread and tolerance requirement. Use a chart from your process documentation or the manufacturer, and avoid guesswork.

Use this document for selection guidance and general process parameters: Technical information Mũi taro ren tay (tạo ren trong) as PDF.

Use a cutting fluid suitable for the workpiece material and the tapping method. Stable lubrication supports surface quality and helps control torque.

For the full overview use: VD 23 catalog as PDF.