Mũi taro ren tay (tạo ren trong) Rougher DIN 2181 HSS-G - M 100 x 3.0

• Use: cắt ren, taro lại ren, and làm sạch ren depending on condition.
• Use it when you need to match the metric designation and pitch stated in the title.
• Use it for ren trong cutting in common engineering materials, depending on cutting conditions.
• Use it as the first stage in a staged Mũi taro ren tay (tạo ren trong) sequence when you want a guided thread start.
• Process: manual driving or assisted driving depending on your holder and machine setup.

Lưu ý Align the tool carefully and use lubrication suitable for your workpiece material to support surface quality and tool life.

• DIN 2181 reference supports standardised selection and documentation in production planning
• Useful when you want to reduce corrective rework by creating a clean initial thread path
• Suitable for routine threading tasks in maintenance and fabrication environments
• Supports a staged tapping sequence where the first pass establishes guidance for later tools

• May not be suitable for very tough materials without a controlled process and appropriate lubrication
• Not intended for fully automated high speed tapping where machine tool synchronisation is required

1. Check the drawing for the required thread designation and confirm the pitch matches the title.
2. Inspect the bore and remove burrs so the tap can enter without side load.
3. Choose lubrication suitable for the material and apply it to the tool and entry area.
4. Clamp the tap securely in a wrench or holder and ensure the tool is guided straight.
5. Begin tapping with steady torque and keep the tool aligned to reduce thread start marking.
6. Advance in a controlled manner and clean chips from the flute space when needed. Technical information Mũi taro ren tay (tạo ren trong) as PDF
7. Back the tool out smoothly, clean the thread, and preserve the tool with light protection oil if used in your shop.

• 1 chiếc: Mũi taro ren tay (tạo ren trong) Rougher DIN 2181 HSS-G - M 100 x 3.0

• Standard: DIN 2181
• Material: HSS-G
• Tool type: Mũi taro ren tay (tạo ren trong) rougher
• Thread designation: M 100 x 3.0
• Thread system: Metric ren trong, as designated in the title
• Execution: Ground, depending on variant

Use suitable lubrication and advance with controlled torque so chips can evacuate through the flute space. Clean the tool as needed to avoid chip packing and surface scoring.

Yes. The thread designation in the title includes both diameter and pitch, which helps you distinguish fine pitch variants from other executions of the same nominal diameter.

Match the metric thread designation in your drawing to the product title, including the pitch value, because the pitch differentiates otherwise similar diameters.

Rougher refers to the first tap stage in a staged hand tapping sequence. You use it to establish the initial thread form and guidance before you use subsequent taps, depending on your set and process.

You can use it for controlled taro lại ren and for cleaning of existing threads when the thread form is intact, but the result depends on thread condition and how much material must be removed.

Keep the tool aligned to the bore axis and apply steady torque. Use a suitable Chất bôi trơn cắt gọt ren and avoid forcing the tap when resistance rises, because misalignment can mark the first thread turns.

For additional information and the full range overview, use the catalog link. VD 23 catalog as PDF