Mũi doa vát mép, HSS-G, 10,4

• Deburr drilled holes and create a chamfer for screw seating and safer handling of edges.
• Use in metal fabrication and maintenance work when a clean entry is required before tapping or assembly.
• Use to remove raised edges that can affect thread start quality and part handling.
• Process: manual driving or assisted driving depending on your holder and machine setup
• Use: cắt ren, taro lại ren, and làm sạch ren depending on condition

Lưu ý Keep the workpiece and tool clean so that thread quality is not affected by debris or burrs.

• Creates a clean chamfer and removes burrs for improved assembly and handling.
• Helps reduce edge deformation that can affect thread starts and fastener seating.
• Compact tool format supports use in hand drills, bit drives, or machine spindles depending on execution.
• Useful as a preparation step in production and maintenance workflows.

• Surface finish can vary with feed and rigidity, especially on thin sheet.
• Not intended for precision countersinking in high volume production lines.

1. Secure the workpiece and ensure the hole is drilled to its intended size and position.
2. Clamp the countersink in your chosen interface so that runout is minimized.
3. Align the tool to the hole axis and start at low feed to establish the chamfer.
4. Increase feed smoothly while monitoring vibration and surface marking.
5. Stop when the chamfer is sufficient for your fastener or deburring requirement.
6. Remove the tool and clean the part to remove chips and burr residue.
7. Inspect the edge and repeat if required for consistent seating.

Scope of supply for Mũi doa vát mép, HSS-G, 10,4 is not specified in the provided product data. Confirm included items and quantities in your order documentation.

• Product type: Mũi doa vát mép
• size: 10,4
• Material: HSS-G ground high speed thép

How do you select the correct countersink for your screw head?
You match the countersink angle and the diameter stated in the product name to the fastener and the required seat. You also consider the machine interface so the tool runs true.

What causes chatter marks during countersinking?
Chatter is usually caused by runout, insufficient rigidity, or too aggressive feed. You improve clamping, reduce feed, and keep the tool sharp and clean.

Can you use the countersink on stainless thép?
Depending on execution and cutting edge condition you can countersink stainless thép, but you use appropriate lubrication and controlled feed to limit heat and work hardening.

How do you avoid burrs at the exit of thin sheet?
You support the sheet, control feed, and stop as soon as the chamfer is sufficient. Excessive penetration can deform the edge.

How do you maintain the tool after use?
You remove chips, wipe the tool clean, and apply light corrosion protection before storage.

Where can you find additional technical information in the catalog?
You can use the catalog for product families, standards references, and selection guidance. VD 23 catalog as PDF

Is 10,4 fixed or part of a variant range?
10,4 is part of the product designation in the provided data. You match it to your drawing and confirm that pitch and thread system also match your requirement.