Bàn ren ngoài (tạo ren ngoài) DIN 223 (DIN EN 22568) HSS - FG 2.6 x 56

• Cut ren ngoài on rods, bolts, and studs in repair, prototyping, and small batch work.
• Use with a Bàn ren ngoài (tạo ren ngoài) holder or Tay quay bàn ren to keep the die square to the workpiece axis.
• Apply cutting fluid matched to your material to reduce friction and protect the thread profile.
• Process: manual driving or assisted driving depending on your holder and machine setup.
• Use: cắt ren, taro lại ren, and làm sạch ren depending on condition.

Lưu ý Confirm thread system, pitch, and fit requirement before cutting. Prepare the workpiece with a clean lead in chamfer.

• Practical for workshop cắt ren without dedicated thread rolling equipment.
• Direct feedback on cutting load during manual use.
• Simple setup with standard die holders.
• Enables maintenance work on damaged ren ngoài.

• Performance is limited in very hard or abrasive materials unless a suitable die execution is selected.
• Cycle time is limited for high volume production compared with dedicated machine processes.

1. Inspect the workpiece and ensure there is a clean lead in chamfer at the thread start.
2. Select a Bàn ren ngoài (tạo ren ngoài) holder and clamp the die securely before you approach the workpiece.
3. Apply cutting fluid to the workpiece area and to the die entry side.
4. Align the die square to the workpiece axis and start cutting with steady forward pressure.
5. Turn the die forward to advance the thread while maintaining alignment.
6. Reverse briefly at intervals to clear chips from the cutting edges.
7. Continue until the required thread length is reached and then stop the forward feed.
8. Back the die off the workpiece and remove it from the holder.
9. Clean the die and verify the thread fit with a matching part or a suitable gauge.

• 1 chiếc: tool as specified by the product name

• Product type: Bàn ren ngoài (tạo ren ngoài)
• Standard: DIN EN 22568; DIN 223
• Thread designation: FG 2.6 x 56
• Tool material: HSS