Hotline: 098 484 7029 Email: [email protected]
折舌工具

断尾工具 11号

★ 0.0 (0 评价)
已售: 0
浏览量: 0
进口自: 德国
产地: 德国

Dụng cụ bẻ chân ren cấy số 11 VÖLKEL, mã 07011, phù hợp cho sửa ren và lắp ren cấy.

SKU: 07011
CN¥36.41
库存状态: 预订 4-8 周
参考价格
描述

Dụng cụ bẻ chân ren cấy số 11

You use Dụng cụ bẻ chân ren cấy số 11 after insert installation when the driving tang has to be removed cleanly so that the repaired thread can be used as intended. It supports a controlled finishing step in sửa ren and insert assembly.

Selection should follow the actual thread designation, the workpiece material and the way the tool is driven or guided in your process.

Ứng dụng

  • Removing the insert tang after installation when the repair process requires a clear through path
  • Completing insert assembly in maintenance and production repair work without damaging the repaired thread
  • Using a dedicated finishing tool instead of improvised impact methods on the insert tang
  • Process: manual driving or assisted driving depending on your holder and machine setup
  • Use: cắt ren, taro lại ren, and làm sạch ren depending on condition

Lưu ý Select the product by thread designation, workpiece condition and the holder concept used in your process.

Lợi ích

  • Matched repair logic supports repeatable restoration of an existing thread designation
  • Insert based repair can improve service life of the receiving thread in repeated assembly work
  • Suitable for maintenance, overhaul and workshop repairs where part replacement is undesirable
  • Clear assignment between preparation, tapping and insert installation reduces handling errors
Hạn chế
  • The process depends on the correct repair sequence and is not suitable when the parent material is cracked or too thin for the repair concept.
  • It is a repair system and not the fastest choice when you only need a one time emergency fix without the full preparation steps.

Các bước thực hiện

  1. Confirm that the insert is seated correctly in the repaired thread before finishing.
  2. Position the Dụng cụ bẻ chân ren cấy centrally over the insert tang.
  3. Apply the removal action in a controlled manner without striking the thread flank area.
  4. Remove the released tang from the hole so the thread path stays clear.
  5. Check the thread entry for burrs or loose fragments.
  6. Clean the tool and store it protected from impact damage.

Phạm vi cung cấp

  • 1 chiếc Dụng cụ bẻ chân ren cấy số 11

Đặc tính kỹ thuật

  • Product type: Dụng cụ bẻ chân ren cấy

Vui lòng dùng biểu mẫu liên hệ.

Sản phẩm cùng loại 11

产品评价

基于 0 条评价
0.0
概览
5★ 0
4★ 0
3★ 0
2★ 0
1★ 0

成为第一个评价“断尾工具 11号”的人

🎁 撰写评价可获得20奖励积分 — 有图片 +10, 有视频 +15积分.
累积奖励积分,兑换Minh Khang Vinatools独特礼品。 登录
请 登录 提交评价。
最近浏览
暂无项目