Mũi taro ren tay (tạo ren trong) Finisher DIN 352 HSS-G - M 22 x 2.5

• Create ren trong in prepared holes for fasteners and assemblies.
• Process: manual driving or assisted driving depending on your holder and machine setup
• Use: cắt ren, taro lại ren, and làm sạch ren depending on condition
• Clean chips from the tool and hole regularly to reduce torque peaks and edge chipping.

Lưu ý Align the tool to the hole axis and avoid forcing, since torque spikes can damage the thread flanks.

• Supports consistent internal threading when alignment is correct
• Usable across common workshop and maintenance processes
• Helps reduce rework through repeatable tool geometry
• Allows controlled fit when you choose the correct thread designation
• Supports predictable results when you keep chips cleared from the cutting area

• Sensitive to misalignment, especially during the first turns
• Not intended for high performance production cycles without validated process parameters

1. Prepare the hole and remove burrs so the tool starts straight.
2. Clamp the workpiece securely and align the tool to the hole axis.
3. Use a suitable holder or drive and apply cutting fluid for the work material.
4. Start the thread with controlled feed and keep the tool guided through the first turns.
5. Continue with steady torque and clear chips from the cutting area as needed.
6. Reverse to remove the tool, then clean the thread and the tool flutes.
7. Check the thread with the intended fastener or a suitable gauge and protect the part.

• 1 chiếc Mũi taro ren tay (tạo ren trong) Finisher DIN 352 HSS-G - M 22 x 2.5

• Product type: Mũi taro ren tay (tạo ren trong)
• Standard: DIN 352
• Thread designation: M
• Tool material: HSS-G