Mũi taro ren tay (tạo ren trong) Intermediate DIN 352 HSS-G - M 22 x 2.5
With Mũi taro ren tay (tạo ren trong) Intermediate DIN 352 HSS-G - M 22 x 2.5 you produce ren trong for fitting parts and assemblies. A controlled setup reduces the risk of damaged first threads.
The designation M 22 x 2.5 identifies the thread you cut. M indicates a ren hệ mét ISO system used widely in general mechanical engineering. HSS-G indicates ground high speed thép, typically chosen for accurate geometry and consistent cutting action. The reference DIN 352 provides a common specification framework for the tool form and designation.
Ứng dụng
- Create ren trong during repair work or low volume production where manual tapping is practical.
- Process: manual driving or assisted driving depending on your holder and machine setup
- Use: cắt ren, taro lại ren, and làm sạch ren depending on condition
- Use cutting fluid suitable for the material and keep the tool square to the hole axis.
Lưu ý Keep the setup clean and check the thread with a gauge or mating part after cutting.
Lợi ích
- Manual control over torque and alignment during cắt ren
- Suitable for workshop repair, maintenance, and low volume production
- Practical for starting threads in assembled or hard to fixture parts
- Ground tool geometry can support consistent cutting action
Hạn chế
- High torque applications can require stronger tooling and rigid fixturing
- Manual operation is slower than automated production methods
Các bước thực hiện
- Prepare the hole with the correct pre machining and add a small entry chamfer.
- Secure the workpiece so it cannot move during tapping.
- Clamp the tap in a suitable Tay quay taro and bring it to the hole axis squarely.
- Apply a cutting fluid matched to the workpiece material.
- Start the first turns with steady pressure while keeping alignment.
- Advance with controlled torque and reverse slightly at intervals to clear chips from the flutes.
- Continue until the required thread depth is reached, then back out smoothly.
- Clean the thread and inspect fit with a gauge or mating part.
Phạm vi cung cấp
- 1 chiếc Mũi taro ren tay (tạo ren trong) Intermediate DIN 352 HSS-G - M 22 x 2.5
Đặc tính kỹ thuật
- Product type: Mũi taro ren tay (tạo ren trong)
- Standard: DIN 352
- Tool material: HSS-G
- Thread designation: M 22 x 2.5
- Thread system: ren hệ mét ISO
Vui lòng dùng biểu mẫu liên hệ.
