Mũi taro ren tay (tạo ren trong) Finisher DIN 352 HSS-G - BSW 2" x 4.5

• Use for workshop threading where you start the tap by hand and manage torque and alignment directly.
• Process: manual driving or assisted driving depending on your holder and machine setup
• Use: cắt ren, taro lại ren, and làm sạch ren depending on condition
• Use cutting fluid suitable for the material and keep the tool square to the hole axis.

Lưu ý Use suitable cutting fluid and stop if torque rises unexpectedly, then inspect alignment and chip evacuation.

• Manual control over torque and alignment during cắt ren
• Suitable for workshop repair, maintenance, and low volume production
• Practical for starting threads in assembled or hard to fixture parts
• Ground tool geometry can support consistent cutting action

• Tool performance depends on correct lubrication and chip evacuation in the hole
• Requires careful alignment to avoid damage to the first threads

1. Prepare the hole with the correct pre machining and add a small entry chamfer.
2. Secure the workpiece so it cannot move during tapping.
3. Clamp the tap in a suitable Tay quay taro and bring it to the hole axis squarely.
4. Apply a cutting fluid matched to the workpiece material.
5. Start the first turns with steady pressure while keeping alignment.
6. Advance with controlled torque and reverse slightly at intervals to clear chips from the flutes.
7. Continue until the required thread depth is reached, then back out smoothly.
8. Clean the thread and inspect fit with a gauge or mating part.

• 1 chiếc Mũi taro ren tay (tạo ren trong) Finisher DIN 352 HSS-G - BSW 2" x 4.5

• Product type: Mũi taro ren tay (tạo ren trong)
• Standard: DIN 352
• Tool material: HSS-G
• Thread designation: BSW 2" x 4.5
• Thread system: BSW