Retainer Rings OS, ALU, 24 x 29 x 2.0
This product is used in practical shop work where alignment, process stability, and correct preparation avoid rework.
Ứng dụng
- Produce clean ren trong when you need a controlled fit for screws and studs.
- Process: manual driving or assisted driving depending on your holder and machine setup
- Use: cắt ren, taro lại ren, and làm sạch ren depending on condition
- Use a suitable Chất bôi trơn cắt gọt ren for the work material and keep the tool aligned to the axis.
Lưu ý Use cutting fluid suitable for the work material and keep the tool aligned during the first turns.
Lợi ích
- Supports consistent internal threading when alignment is correct
- Usable across common workshop and maintenance processes
- Helps reduce rework through repeatable tool geometry
- Allows controlled fit when you choose the correct thread designation
- Helps keep thread quality stable when you use appropriate lubrication
Hạn chế
- Sensitive to misalignment, especially during the first turns
- Requires careful handling to avoid edge damage in busy shop environments
Các bước thực hiện
- Prepare the hole and remove burrs so the tool starts straight.
- Clamp the workpiece securely and align the tool to the hole axis.
- Use a suitable holder or drive and apply cutting fluid for the work material.
- Start the thread with controlled feed and keep the tool guided through the first turns.
- Continue with steady torque and clear chips from the cutting area as needed.
- Reverse to remove the tool, then clean the thread and the tool flutes.
- Check the thread with the intended fastener or a suitable gauge and protect the part.
Phạm vi cung cấp
- 1 chiếc Retainer Rings OS, ALU, 24 x 29 x 2.0
Đặc tính kỹ thuật
Vui lòng dùng biểu mẫu liên hệ.
