Retainer Rings OS, CU, 24 x 29 x 2.0

• Produce clean ren trong when you need a controlled fit for screws and studs.
• Process: manual driving or assisted driving depending on your holder and machine setup
• Use: cắt ren, taro lại ren, and làm sạch ren depending on condition
• Use a suitable Chất bôi trơn cắt gọt ren for the work material and keep the tool aligned to the axis.

Lưu ý Align the tool to the hole axis and avoid forcing, since torque spikes can damage the thread flanks.

• Supports consistent internal threading when alignment is correct
• Usable across common workshop and maintenance processes
• Helps reduce rework through repeatable tool geometry
• Allows controlled fit when you choose the correct thread designation

• Limited by work material hardness and by the stability of your clamping setup
• Not intended for high performance production cycles without validated process parameters

1. Prepare the hole and remove burrs so the tool starts straight.
2. Clamp the workpiece securely and align the tool to the hole axis.
3. Use a suitable holder or drive and apply cutting fluid for the work material.
4. Start the thread with controlled feed and keep the tool guided through the first turns.
5. Continue with steady torque and clear chips from the cutting area as needed.
6. Reverse to remove the tool, then clean the thread and the tool flutes.
7. Check the thread with the intended fastener or a suitable gauge and protect the part.

• 1 chiếc Retainer Rings OS, CU, 24 x 29 x 2.0

• Product type: Tool