Hotline: 098 484 7029 Email: [email protected]
Holzbohrer

Mũi khoan gỗ 6mm chuôi lục giác 6.3mm, Voelkel 67660

★ 0.0 (0 Bewertungen)
Verkauft: 0
Aufrufe: 0
Importiert aus: Deutschland
Herkunft: Deutschland

Wood Mũi khoan, HSS-G, 6,0 VÖLKEL, mã 67660, phù hợp cho khoan kim loại và chuẩn bị lỗ taro.

SKU: 67660
5,27 €
Lagerstatus: Nachbestellung 4-8 Wochen
Richtpreis
Beschreibung

Wood Mũi khoan, HSS-G, 6,0

Use this Mũi khoan for general drilling tasks in maintenance and fabrication, where correct setup and lubrication influence tool life.

Selection depends on your work material and the process step, for example drilling for assembly or hole preparation before threading. HSS-G indicates a ground high speed thép tool, typically selected when edge definition and repeatability matter.

Ứng dụng

  • Produce holes for fasteners, pins, and general fabrication work in workshop and site service.
  • Process: manual driving or assisted driving depending on your holder and machine setup
  • Use: cắt ren, taro lại ren, and làm sạch ren depending on condition
  • Use a suitable Chất bôi trơn cắt gọt ren for the work material and keep the tool aligned to the axis.

Lưu ý Use a stable setup and correct lubrication for the alloy to avoid heat driven wear.

Lợi ích

  • General purpose hole making for workshop tasks
  • Stable cutting edges when your setup is consistent
  • Suitable for preparation steps before threading and assembly
  • Simple tool selection when diameter is defined in the product name
  • Suitable for routine use in metal fabrication and plant engineering service
Hạn chế
  • Limited by work material hardness and by the stability of your clamping setup
  • Not intended for high performance production cycles without validated process parameters

Các bước thực hiện

  1. Mark the drilling point and secure the workpiece with stable clamping.
  2. Center the tool and start with straight alignment to the surface.
  3. Apply suitable lubrication for the work material if your process requires it.
  4. Drill with consistent feed while allowing chips to evacuate freely.
  5. Retract to clear chips when needed and avoid rubbing at low feed.
  6. Deburr the hole edge and clean the bore before the next process step.

Phạm vi cung cấp

  • 1 chiếc Wood Mũi khoan, HSS-G, 6,0

Đặc tính kỹ thuật

  • Product type: Wood Mũi khoan
  • Tool material: HSS-G

Vui lòng dùng biểu mẫu liên hệ.

Produktbewertungen

Basierend auf 0 Bewertungen
0.0
Übersicht
5★ 0
4★ 0
3★ 0
2★ 0
1★ 0

Be the first to review “Mũi khoan gỗ 6mm chuôi lục giác 6.3mm, Voelkel 67660”

🎁 Schreiben Sie eine Bewertung und erhalten Sie 20 Bonuspunkte — Foto +10, Video +15.
Sammeln Sie Prämienpunkte, um einzigartige Geschenke von Minh Khang Vinatools einzulösen. Anmelden
Bitte anmelden um eine Bewertung abzugeben.
Kürzlich angesehen
Noch keine Artikel