Bàn ren ngoài (tạo ren ngoài) DIN 223 (DIN EN 22568) HSS - BSW 1.5/8 x 5
You restore or create ren ngoài with a Bàn ren ngoài (tạo ren ngoài) when machine access is limited. The result depends on correct preparation, alignment, and lubrication.
Match the die to your thread requirement and clamp it securely in a Bàn ren ngoài (tạo ren ngoài) holder. Start square to the workpiece axis and use lubrication to reduce friction and wear.
Ứng dụng
- Cut ren ngoài on rods, bolts, and studs in repair, prototyping, and small batch work.
- Use with a Bàn ren ngoài (tạo ren ngoài) holder or Tay quay bàn ren to keep the die square to the workpiece axis.
- Apply cutting fluid matched to your material to reduce friction and protect the thread profile.
- Process: manual driving or assisted driving depending on your holder and machine setup.
- Use: cắt ren, taro lại ren, and làm sạch ren depending on condition.
Lưu ý Confirm thread system, pitch, and fit requirement before cutting. Prepare the workpiece with a clean lead in chamfer.
Lợi ích
- Supports repeatable cắt ren in small batches with minimal setup.
- Good access in confined work areas compared with larger machines.
- Easy to clean and store as an individual tool.
- Works well for service tasks when the correct preparation is in place.
Hạn chế
- Performance is limited in very hard or abrasive materials unless a suitable die execution is selected.
- Cycle time is limited for high volume production compared with dedicated machine processes.
Các bước thực hiện
- Inspect the workpiece and ensure there is a clean lead in chamfer at the thread start.
- Select a Bàn ren ngoài (tạo ren ngoài) holder and clamp the die securely before you approach the workpiece.
- Apply cutting fluid to the workpiece area and to the die entry side.
- Align the die square to the workpiece axis and start cutting with steady forward pressure.
- Turn the die forward to advance the thread while maintaining alignment.
- Reverse briefly at intervals to clear chips from the cutting edges.
- Continue until the required thread length is reached and then stop the forward feed.
- Back the die off the workpiece and remove it from the holder.
- Clean the die and verify the thread fit with a matching part or a suitable gauge.
Phạm vi cung cấp
- 1 chiếc: tool as specified by the product name
Đặc tính kỹ thuật
- Product type: Bàn ren ngoài (tạo ren ngoài)
- Standard: DIN EN 22568; DIN 223
- Thread designation: BSW 1.5/8 x 5
- Thread system: BSW
- Tool material: HSS
Vui lòng dùng biểu mẫu liên hệ.
